Switch 7700 Configuration Guide

4 CHAPTER 1: SYSTEM ACCESS
Configuring the
Switch 7700
On the Switch 7700, you can set up the configuration environment through the
console port. To set up the the local configuration environment:
1 Plug the DB-9 or DB-25 female plug of the console cable into the serial port of the
PC or the terminal where the switch is to be configured.
2 Connect the RJ-45 connector of the console cable to the console port of the
switch, as shown in
Figure 1.
Figure 1 Setting up the Local Configuration Environment Through the Console Port
Security features Multi-level user management and password protect
802.1X authentication
Packet filtering
Reliability Virtual Redundancy Routing Protocol (VRRP)
Quality of Service (QoS) Traffic classification
Bandwidth control
Priority
Queues of different priority on the port
Queue scheduling: supports Strict Priority Queueing (SP)
Management Command line interface configuration
Configuration via Console port
Remote configuration via Telnet
Configuration through dialing the Modem
SNMP
System log
Level alarms
Loading and update Load and upgrade software via XModem protocol
Load and upgrade software via File Transfer Protocol (FTP)
and Trivial File Transfer Protocol (TFTP)
Maintenance Output of the debugging information
PING and Tracert
Remote maintenance via Telnet and Modem
Table 1 Function Features
Features Support
RS-232 Serial port
Console cable
Console port