Switch 7700 Configuration Guide

Setting Terminal Parameters 13
To number the user interface by relative number, represented by interface +
number assigned to each type of user interface:
■ AUX user interface = AUX 0.
■ The first VTY interface = VTY 0, the second one = VTY 1, and so on.
To configure the user interface:
■ Enter the User Interface View
■ Configure the Attributes of the AUX (Console) Port
■ Configure the Terminal Attributes
■ Manage Users
■ Configure the Attributes of a Modem
■ Configure Redirection
Enter the User Interface View
Use the user-interface command (see Table 2) to enter a user interface view. You
can enter a single user interface view or multi-user interface view to configure one
or more user interfaces.
Perform the following configuration in system view.
Configure the Attributes of the AUX (Console) Port
Use the speed, flow control, parity, stop bit, and data bit commands (see
Table 3) to configure these attributes of the AUX (Console) port.
Perform the following configurations in user interface (AUX user interface only)
view.
Tabl e 2 Enter User Interface View
Operation Command
Enter a single user interface view or
multi user interface views
user-interface [ type ] first-number [ last-number ]
Tabl e 3 Configure the Attributes of the AUX (Console) Port
Operation Command
Configure the transmission
speed on AUX (Console) port.
By default, the transmission
speed is 9600bps
speed speed-value
Restore the default
transmission speed on AUX
(Console) port
undo speed
Configure the flow control on
AUX (Console) port. By
default, no flow control is
performed on the AUX
(Console) port
flow-control { hardware | none | software }
Restore the default flow
control mode on AUX
(Console) port
undo flow-control