Switch 7700 Configuration Guide

Device Management 11
Example: Configuring
MAC Address Table
Management
The user logs in the switch via the Console port to configure the address table
management. Set the address aging time to 500s and add a static address
00e0-fc35-dc71 to Ethernet 1/0/2 in vlan1.
Figure 2 Typical Configuration of Address Table Management
Configuration procedure
1 Enter the system view of the switch.
<SW7700> system-view
2 Add a MAC address (specify the native VLAN, port and state).
[SW7700] mac-address static 00e0-fc35-dc71 interface Ethernet 1/0/2
vlan 1
3 Set the address aging time to 500s.
[SW7700] mac-address timer 500
4 Display the MAC address configurations in all views.
[SW7700] display mac-address interface Ethernet 1/0/2
MAC ADDR VLAN ID STATE PORT INDEX AGING TIME(s)
00-e0-fc-35-dc-71 1 Static Ethernet1/0/2 NOAGED
00-e0-fc-17-a7-d6 1 LearnedEthernet1/0/2 300
00-e0-fc-5e-b1-fb 1 Learned Ethernet1/0/2 300
00-e0-fc-55-f1-16 1 Learned Ethernet1/0/2 300
Device Management With device management, the Switch 7700 displays the current running state and
event debugging information about the slots and physical devices. In addition,
there is a command for rebooting the system, when a function failure occurs.
The device management configuration task is simple. As far as a user concerned, it
is mainly the display and debug the device management.
Disable the address table
management debugging
undo debugging mac-address
Table 19 Display and Debug MAC Address Table
Operation Command
Console port
Network port
Internet
Switch