Switch 7700 Configuration Guide

18 CHAPTER 1: SYSTEM ACCESS
Perform the following configuration in system view.
Configure the Attributes of a Modem
You can use the commands described in Table 14 to configure the attributes of a
modem when logging in to the switch through the modem.
Perform the following configuration in user interface view.
Configure Redirection
The send command can be used for sending messages between user
interfaces. See
Table 15.
Perform the following configuration in user view.
The auto-execute command is used to run a command automatically after
you log in. The command is automatically executed when you log in again. See
Tabl e 16.
This command is usually used to execute the telnet command automatically on
the terminal, which connects the user to a designated device.
Tab le 13 Set Command Priority
Operation Command
Set the command priority in a
specified view.
command-privilege level level view view command
Restore the default command
level in a specified view.
undo command-privilege view view command
Tab le 14 Configure Modem
Operation Command
Set the interval since the system
receives the RING until CD_UP
modem timer answer seconds
Restore the default interval since
the system receives the RING until
CD_UP
undo modem timer answer
Configure auto answer modem auto-answer
Configure manual answer undo modem auto-answer
Configure to allow call-in modem call-in
Configure to bar call-in undo modem call-in
Configure to permit call-in and
call-out.
modem both
Configure to disable call-in and
call-out
undo modem both
Tab le 15 Configure to Send Messages Between User Interfaces
Operation Command
Configure to send messages
between different user interfaces.
send { all | number | type number }