Switch 7700 Configuration Guide

36 CHAPTER 2: PORT CONFIGURATION
Mode: both
Ethernet Link
Aggregation
Troubleshooting
When configuring link aggregation, you might see a message that the
configuration has failed. To address this situation:
■ Check the input parameter and see whether the starting number of Ethernet
port is smaller than the end number. If yes, take the next step.
■ Check whether the Ethernet ports that are in the configured range belong to
any other existing link aggregations. If not, take the next step.
■ Check whether the ports to be aggregated operate in the same speed and full
duplex mode. If yes, take the next step.
■ If correct, configure the link aggregation again.