Switch 7700 Configuration Guide

RIP 73
Perform the following configurations in RIP view.
By default, the preference of RIP is 100.
Set Additional Routing Metric
The additional routing metric is the input or output routing metric added to an RIP
route. It does not change the metric value of the route in the routing table, but
adds a specified metric value when the interface receives or sends a route.
Perform the following configuration in VLAN interface view.
By default, the additional routing metric added to the route when RIP sends the
packet is 1. The additional routing metric when RIP receives the packet is 0 by
default.
Configure Route Filtering
The router provides the route filtering function. You can configure the filter policy
rules by specifying the ACL and ip-prefix for route redistribution and distribution.
Besides, to import a route, the RIP packet of a specific router can also be received
by designating a neighbor router.
Perform the following configurations in RIP view.
Tabl e 17 Set the RIP Preference
Operation Command
Set the RIP Preference preference value
Restore the default value of
RIP preference
undo preference
Tabl e 18 Set Additional Routing Metric
Operation Command
Set the additional routing
metric of the route when the
interface receives an RIP
packet
rip metricin value
Disable the additional routing
metric of the route when the
interface receives an RIP
packet
undo rip metricin
Set the additional routing
metric of the route when the
interface sends an RIP packet
ip metricout value
Disable the additional routing
metric of the route when the
interface sends an RIP packet
undo rip metricout
Tabl e 19 Configure RIP to Filter Routes
Operation Command
Configure RIP to Filter Received Routes
Configure filtering the received
routing information distributed by
the specified address
filter-policy gateway ip-prefix-name import