Version 6 SuperStack 3 Switch 4400 Management Interface Reference Guide

Table Of Contents
Command Line Interface - security radius retries
http://support.3com.com/infodeli/tools/switches/4400/DHA1720-3AAA08/htmcli/securityradiusretries.htm[11/15/2010 3:45:39 PM]
Command Line Interface
security radius retries
Modifying the RADIUS Retry Parameters
You can modify the RADIUS retry parameters for all RADIUS servers on your network
using the retries command on the radius menu.
To modify the RADIUS retry parameters:
1. From the Top-level menu, enter:
security radius retries
The following prompt is displayed:
Enter maximum attempts (1-10) [4]:
2. Enter the maximum number of attempts that you wish your RADIUS servers to
allow.
The following prompt is displayed:
Enter timeout (1-10) [2]:
3. Enter the number of seconds that you wish to be the timeout value for your
RADIUS servers.
Related Commands
logins Displaying Authentication Login Attempts
statistics Displaying Authentication Statistics
summary Displaying Authentication Summary Information
systemMode Modifying Authentication Mode
setup Using the RADIUS Configuration Wizard
accounting display Displaying RADIUS Accounting Statistics
accounting modify Modifying RADIUS Accounting Configuration
authentication display Displaying RADIUS Authentication Statistics
authentication modify Modifying RADIUS Authentication Configuration
sharedSecret Modifying RADIUS Security Key
radius summary Displaying RADIUS Summary Information