Version 6 SuperStack 3 Switch 4400 Management Interface Reference Guide

Table Of Contents
Command Line Interface - physicalInterface ethernet automdix
http://support.3com.com/infodeli/tools/switches/4400/DHA1720-3AAA08/htmcli/physicalinterfaceethernetautomdix.htm[11/15/2010 3:47:40 PM]
Command Line Interface
physicalInterface ethernet autoMDIX
Enabling or Disabling autoMDIX on a Port
You can enable or disable auto negotiation on a single Ethernet port using the autoMDIX
command on the ethernet menu.
To change the auto MDIX status on a port:
1. At the Top-level menu, enter:
physicalInterface ethernet autoMDIX
The following prompt is displayed:
Select port (unit:port,?):
2. Enter the number of the port.
The following prompt is displayed:
Enter new value (enable,disable)[disable]:
3. Enter enable or disable.
Related Commands
flowControl Enabling and Disabling Flow Control
portCapabilities Setting the Port Capabilities
portMode Specifying the Speed and Duplex Mode
portState Enabling and Disabling Ports
smartAutosense Enabling/Disabling Smart Autosensing
summary Displaying Port Summary Information