Version 6 SuperStack 3 Switch 4400 Management Interface Reference Guide

Table Of Contents
Support - Problem Solving - RADIUS Problems
http://support.3com.com/infodeli/tools/switches/4400/DHA1720-3AAA08/htm/support/problemsolving/radiusproblems.htm[11/15/2010 3:44:14 PM]
When using the Web interface, the Session History table, accessed by
selecting
Security > Device > Authentication > Logins, displays two
entries for the same login session, each showing different access times.
The first entry shows the time of the initial login and the second entry
shows the time of the latest access.
The Switch has been reset and an Accounting-Stop packet has
not been sent to the RADIUS server.
The Switch 4400 will not send an Accounting-Stop packet in the event
that it is reset or rebooted. Usually an Accounting-Stop packet is sent
to mark the end of an Accounting session. This will not cause any data
loss to Accounting records on the RADIUS server.
The RADIUS server is not successfully checking for NAS-Port.
The RADIUS NAS-Port attribute is sent in the format (stack-unit)+(2-
digit-port-number). For example, port 6 on stack unit 2 would be 206.
Port 12 on stack unit 3 would be 312. On a single Switch, when setting
up a check list item for NAS-Port "6", you would need to configure it to
check for "106". This attribute is only sent during Network Login
sessions.
Related Sections
Web Interface Problems
Command Line Interface Problems
VLAN Problems
Link Aggregation Problems
SNMP Management Software Problems
Management Software Upgrade Problems
Software Update Utility Problems
Other Problems