Version 6 SuperStack 3 Switch 4400 Management Interface Reference Guide

Command Line Interface - system management remoteAccess
http://support.3com.com/infodeli/tools/switches/4400/DHA1720-3AAA08/htmcli/systemmanagementremoteaccess.htm[11/15/2010 3:45:06 PM]
Command Line Interface
system management remoteAccess
Enabling and Disabling Remote Access
As a basic security measure, you can enable or disable remote access to the
management software of the stack:
When remote access is enabled, you can access the management software using
all management methods.
When remote access is disabled:
Users cannot access the stack over the network using the command line
interface.
Users cannot access the stack over the network using the web interface.
Users cannot access the stack using an SNMP Network Manager.
Users can only access the command line interface or web interface using a
direct connection to the console port of a Switch unit in the stack.
You can enable or disable remote access to the management software of the stack using
the remoteAccess command on the Management menu.
To enable or disable remote access:
1. At the Top-level menu, enter:
system management remoteAccess
2. The following prompt is displayed:
Enter new value (enable,disable) [enable]:
3. Enter enable or disable as required.
Related Commands
contact Specifying a Contact Name for the Stack
location Specifying Stack Location Details
name Specifying a Stack Name
password Changing Your Password