HP 7500/E7900 Switches and Fabric Modules - 7500-CMW520-R6708 Release Notes

10
 Condition: This symptom occurs if a packet matches two entries in the PBR policy
LSD074042
 Symptom: Walking the entPhysicalVendorType MIB fails to get the transceiver information on
the Combo interfaces.
 Condition: This symptom can be seen during a walk on the entPhysicalVendorType MIB.
LSD074025
 Symptom: The CPU usage on the 40G card is high when the switch operates normally.
 Condition: This symptom might be seen when the switch operates normally.
Resolved problems in F6707L02
LSD073211
 Symptom: A user might fail to pass remote AAA authentication, such as dot1x authentication.
 Condition: This symptom might occur when remote AAA authentication is configured.
LSD073303
 Symptom: The monitor handshake-timeout disable-port command fails to take effect after a reboot.
 Condition: This symptom can be seen after a reboot.
LSD073221
 Symptom: The remark dot1p action for colored packets modifies only the 802.1p priority in VLAN
tags, but does not modify the local precedence, which is used for enqueuing packets.
 Condition: This symptom can be seen when the remark dot1p action is configured.
LSD073429
 Symptom: BGP does not accept routes with an aggregator ID of 0.0.0.0.
 Condition: This symptom can be seen when BGP receives a route with an aggregator ID of 0.0.0.0
from a device of another vendor.
LSD073782
 Symptom: On an SA card, SFTP and SSH packets are forwarded slowly (less than 100 Kbps).
 Condition: This symptom can be seen when SFTP and SSH packets are forwarded by an SA card.
Resolved problems in F6707
LSD072994
 Symptom: An SNMP walk on power MIB returns an incorrect value.
 Condition: This symptom occurs during an SNMP walk on power supply unit related MIB.
LSD072017
 Symptom: The device generates a useless log "Send PAAT to all IO boards has failed."
 Condition: This symptom might occur during the startup of a card installed with a specific fiber
module.