ProCurve Switch xl Modules Installation Guide 2004-05

7
HP ProCurve Switch xl Modules
Installing the Modules
1. Insert module into the
guides and slide it in until it
is fully inserted.
“Low-force” connector.
High insertion force is not
needed and should not be
used.
For best results, push
simultaneously near
both screws.
2. Then tighten the retaining
screws on the module until they are
secure, but do not overtighten
them.
The module is fully inserted when
the module bulkhead is contacting,
or very close to contacting
the face of the switch.