2424m Gigabit Stacking Kit Installation Guide 1999-03
3
Insert the Transceiver Into the Slot
The Stacking Transceivers are installed into the Gigabit Stacking Module,
as follows:
1. Remove the Gigabit Stacking Module from the Switch 2424M, or unplug
the Switch 2424M from the AC power source. Then, using a flat-bladed
or Torx T-10 screwdriver, unscrew the two retaining screws on the slot
cover plate or existing transceiver, and remove it from the module.
Keep the cover plate for future use—unused transceiver slots should
be kept covered for proper switch operation.
2. Slide the transceiver firmly into the transceiver slot as far as it will go.
The transceiver will “snap” into place, and the transceiver's faceplate
should touch the face of the module.
3. Using the flat-bladed or Torx T-10 screwdriver, tighten the retaining
screws on the transceiver until they are secure, but be careful that you
do not overtighten the screws.
4. Reinstall the module into the switch and make sure the switch is
powered on, or simply power on the switch if you did not remove the
module.
loosen these screws and remove the cover plate
slide the transceiver into the
slot until it snaps into place
MIP3DJH0RQGD\0DUFK30