Installation Guide for cl Modules 2006-03

Installing the Modules

Installing or Removing the transceivers

If you installed a copper module you can now connect the cables. If you

installed a media flex module, you can now install the transceivers.

You can install or remove a transceiver from the Media Flex cl Module without

having to power off the switch. Use only ProCurve transceivers.

Installing the transceivers:

WARNING The ProCurve X2 fiber optic transceivers are Class 1 or Class 1M laser

devices. Avoid direct eye exposure to the beam coming from the

transmit port.

1. Remove a port cover by squeezing the metal tabs together.

Note When switch power is on, the Link and Activity LEDs will come on for

approximately two seconds and then go off. This is confirmation the

transceiver is installed.

4. If your transceiver has a bail, move the bail up to lock the transceiver in

place, if not your transceiver is now completely installed. Network cables

can now be connected, see page 10.

Removing the transceivers:

You should disconnect the network cable from the transceiver before

removing it from the module.

If your transceiver has a wire bail, lower the bail until it is approximately

horizontal, and then using the bail, pull the transceiver from the slot. If your

transceiver does not have a bail, pull the transceiver straight out.

2. Slide the transceiver into either slot until it stops.

3. Push firmly until you hear a click and the gasket seats

against the bulkhead. .

Bail