Installation Guide for cl Modules 2006-03

Removing a Module

Note Installing or removing a module with the switch powered on causes a switch

reset to occur.

Follow these procedures to remove a module:

1. Remove any network cables from the ports on the module.

2. On the module unscrew the retaining screws enough to disconnect them

from the threaded holes in the switch.

3. Using the extractor handles, pull the module out from the slot.

4. Do one of the following:

• If you will be installing another module in the slot, go to “Installing a

Module” on page 6 and begin with step 2.

• If you will not install another module in the slot (that is, leave it

empty), then re-install a slot cover plate over the empty slot opening.

Caution For proper cooling and reduction of electromagnetic emissions, ensure a slot

cover is installed on any unused slot.

Pull extractor handles

unscrew the retaining screws