Release Notes K.12.26

57
Enhancements
Viewing the RL-PACL Information
Note
RL-PACLs and other ACL types (normal PACLs, VACLs, RACLs, etc.) operate on packets at the same
time. If any ACL indicates the packet should be dropped, the packet is dropped. However, the packet
will still count towards RL-PACL meter usage.
To turn off the rate limiting enter this command:
Figure 2. Turning off Rate-Limiting for the Configured Ports
Viewing the RL-PACL Information
An enhanced rate-limit CLI command displays information about the rate-limiting configured on each
port for each group.
Syntax: show rate-limit ip access-group <[ethernet] port-list>
Figure 3. Example of show rate-limit Command for RL-PACLs
Show Access Lists by Port
Figure 4 shows the ACL information for a specific port.
ProCurve(config)# no interface 4-8 rate-limit ip access-group
ProCurve(config)# show rate-limit ip access-group
Inbound access-group rate-limits:
Port kbps Access-group name
----- -------- -----------------
4 10000 Group_A
5 10000 Group_A
6 10000 Group_A
7 10000 Group_A
8 10000 Group_A
Ports with no RL-PACL applied are not displayed in
the output.