Installation and Reference Guide HP AdvanceStack 100Base-THub-12TX, Hub-12TXM, and Switch Modules 1997-06

HP Hub-12TX/Hub-12TXM Installation and Reference Guide
Configuring the System 4-21
Entity Field Description
SNMP Agent Bootup Option Specifies bootup method as -
NORMAL - Use on-board ROM code and default IP address.
TFTP DOWNLOAD - Get system code from TFTP server (and use default IP
address). This process is repeated each time power to the hub is reset.
BOOTP GET IP - Get IP address from server (and use on-board ROM code).
BOOTP DOWNLOAD - Get IP address and system code from server. Image is
stored in temporary memory.
NO BOOTP TFTP REQUEST - Do not issue BOOTP request. Wait for download
via out-of-band.
BOOTP UPGRADE FIRMWARE - Get IP address and system code from server.
Image is stored in nonvolatile memory, and BOOTP option reset to NORMAL. Note
that this is the only network option that places the image in nonvolatile memory.
Table 4.11 Hub Configuration Menu
Hub ID Configuration
To change the numeric hub identifier, select Hub ID
Configuration from the Hub Configuration: Hub Selection
menu shown above. The following Hub ID Configuration
menu will appear. After changing a hub identifier, verify the
change with “Update Above Settings” command. Note that
Position 1 means that the hub has no Stacking Cable on its “
In”
port.
HP J3233A AdvanceStack 100Base-T Hub-12TXM
Hub ID Configuration
---------------------------
Back to Previous Menu
Position Hub ID
1. 1
2. NOT PRESENT
3. NOT PRESENT
4. NOT PRESENT
5. NOT PRESENT
Update Above Settings
Back to previous menu.
<Enter> to confirm, <Ctrl+Z> to back to Main Menu
Figure 4.13 Hub ID Configuration Menu