Installation and Reference Guide HP AdvanceStack 100Base-THub-12TX, Hub-12TXM, and Switch Modules 1997-06

HP Hub-12TX/Hub-12TXM Installation and Reference Guide
Configuring the System 4-23
HP J3233A AdvanceStack 100Base-T Hub-12TXM
Port Configuration
------------------------------
Back to Previous Menu
Hub ID : 1 Position : 1
Port ID Name Admin State Oper State Link State Partition
1. ENABLED ENABLED DOWN NO
2. ENABLED ENABLED DOWN NO
3. ENABLED ENABLED DOWN NO
4. ENABLED ENABLED DOWN NO
5. ENABLED ENABLED DOWN NO
6. ENABLED ENABLED DOWN NO
7. ENABLED ENABLED DOWN NO
8. ENABLED ENABLED DOWN NO
9. ENABLED ENABLED DOWN NO
10. ENABLED ENABLED DOWN NO
11. ENABLED ENABLED DOWN NO
12. ENABLED ENABLED DOWN NO
Back to previous menu.
<Enter> to confirm, <Ctrl+Z> to back to Main Menu
Figure 4.15 Port Configuration Menu
Menu items are briefly described in the following table.
Field Description
Hub ID Hub identifier within the stack.
Position The physical position in the stack (as determined by position from the hub with no connection on
its “In” port).
Port ID Numeric identifier 1~12 or Exp Slot
Name User-defined name for selected port.
Admin State User-configured state for the port.
Oper State The current operating state of the port. Any port may be automatically ENABLED or DISABLED if
configured as one of a Backup Link pair.
Link State Indicates if the port has a valid connection to an external device.
Partition Indicates if the port is partitioned. (Refer to Partition/Disable Indicators in Chapter 5 for a more
detailed description of the reasons a port may be partitioned.)
Table 4.12 Port Configuration Menu
Configuring the Switch Port Module
If you select Exp Slot (i.e., Switch Port Module) on the Port
Configuration: Port Selection menu, the Exp Slot Port
Configuration Menu will open. This menu allows you to
configure various communication parameters for this module.