Installation and Reference Guide HP AdvanceStack 100Base-THub-12TX, Hub-12TXM, and Switch Modules 1997-06

HP Hub-12TX/Hub-12TXM Installation and Reference Guide
4-26 Configuring the System
Menu items are briefly described in the following table.
Field Description
Hub ID Hub identifier within the stack.
Position The physical position in the stack (as determined by its position from the top of the Stacking Cable).
Port ID Selects any station port (1~12) on the hub.
Authorized MAC
Address
Defines the MAC address that is authorized to attach to this port.
Intrusion Action Response to a detected intrusion can be set to:
INACTIVE - no action taken,
WARNING - trap message is issued to the management station, or
WARNING & DISABLE - trap message is issued and port is disabled.
Note: If a port is disabled by an unauthorized intrusion attempt, it must be manually re-enabled
using the Admin State field in the Port Configuration menu.
Table 4.14 Port Intrusion Control Menu
Defining Backup Ports
Select Backup Links under the System Configuration menu to
define up to 10 master/backup port pairs. If the connection to
the master port fails, the backup port will automatically take
over. For greater reliability, primary and backup ports should
be located on different hubs. Use the following menu to
specify and activate backup link pairs.
HP J3233A AdvanceStack 100Base-T Hub-12TXM
Backup Links
--------------------
Back to Previous Menu
Set Primary Port Backup Port Port Backup Status
1. Hub: 1 Port: 1 Hub: 2 Port: 1 Enabled Primary
2. Hub: 1 Port: 2 Hub: 2 Port: 2 Enabled Backup
3. Hub: 1 Port: 3 Hub: 2 Port: 3 Disabled
4. Hub: 1 Port: 1 Hub: 1 Port: 1 Disabled
5. Hub: 1 Port: 1 Hub: 1 Port: 1 Disabled
6. Hub: 1 Port: 1 Hub: 1 Port: 1 Disabled
7. Hub: 1 Port: 1 Hub: 1 Port: 1 Disabled
8. Hub: 1 Port: 1 Hub: 1 Port: 1 Disabled
9. Hub: 1 Port: 1 Hub: 1 Port: 1 Disabled
10. Hub: 1 Port: 1 Hub: 1 Port: 1 Disabled
Back to previous menu.
<Enter> to confirm, <Ctrl+Z> to back to Main Menu
Figure 4.19 Backup Links Menu