3Com® Switch 5500G Open Services Networking Configuration and Command reference Guide

Configuring ACFP 15
■ Inverse mask of destination IP address
■ Destination port number operator: Its type can be equal to, not
equal to, greater than, less than, greater than and less than. The
following ending destination port number is meaning only when the
type is greater than and less than. The destination port number of
the packets matched by the identifier must be greater than the
starting destination port number and less than the ending destination
port number.
■ Starting destination port number
■ Ending destination port number
■ Pro: Protocol type, which can be GRE, ICMP, IGMP, OSPF, TCP, UDP,
and IP.
■ IP precedence: Packet precedence, a number in the range of 0 to 7.
■ IP ToS: Type of Service (ToS) of the IP
■ IP DSCP: Differentiated Services Code Point (DSCP) of the IP
■ TCP control packet: Indicates whether the packet is a TCP control
packet.
■ IP fragment: Indicates whether the packet is an IP packet fragment.
■ Rate limit
■ Row state
You can use the collaboration policy to manage the collaboration rules
that belong to it.
n
The Switch 5500G Ethernet does not support ACFP’s pass-through mode.
Using ACFP
■ ACFP does not process IPv6 packets.
■ With ACFP, a stream cannot be mirrored or redirected to multiple
ACFP clients.
Configuring ACFP Follow these steps to configure ACFP.
To... Use the command... Remarks
Enter system view system-view -