3Com® Switch 5500G Open Services Networking Configuration and Command reference Guide

26 Chapter 3: Configuring an Application Control System Exchange Interface
■ For a description of the osm connect unit command, refer to “osm
connect unit” on page 31.
■ The above rpm commands are Linux operating system commands and
not covered in this document.
Configuring the
Default Startup
Settings for an ACSEI
Client
The ACSEI client is enabled once it is installed, and by default, after the
Linux system starts up, it starts up the ACSEI client automatically. You can
modify the default setting using the following commands.
Modifying the default startup setting through the command line
interface (CLI)
Follow these steps to configure the ACSEI client’s default startup setting:
Modifying the default startup settings through GUI
To modify the default startup settings through the GUI, perform the
following steps:
1 Execute the osm connect unit command in user view to enter the
OSN|M’s Linux system.
2 Execute the setup command and the ACSEI GUI is displayed as shown in
Figure 4.
To... Use the command... Remarks
Switch to the OSN|M’s
Linux OS from the switch’s
CLI
osm connect unit unit-id Required
Available in user view
After the operation, the
operating interface is
switched to the Linux
system interface where
you can execute the
following commands.
Configure the ACSEI client
to not start automatically
when the Linux system is
started
chkconfig acseid off Required
By default, the ACSEI
client is started up
automatically with the
startup of the Linux
system.
Configure the ACSEI client
to start up automatically
when the Linux system is
started
chkconfig acseid on Required
By default, ACSEI client is
started up automatically
with the startup of the
Linux system.