3Com® Switch 5500G Open Services Networking Configuration and Command reference Guide

32 Chapter 4: OSN|M Configuration Commands
osm reboot unit
Syntax osm reboot unit unit-id
View User view
Parameters unit unit-id: Specifies a switch by its unit ID.
Description Use the osm reboot unit command to restart the OSN|M’s Linux OS on
the specified switch. You can specify the unit ID of the local switch or the
unit ID of another switch in the same fabric as the local switch.
Note that before restarting an OSN|M, 3Com recommends that you save
the data on the Linux OS and shut down the Linux OS to avoid service
interruption and hardware data loss.
Examples # Restart the OSN|M’s Linux OS on unit 1.
<SW5500G> osm reboot unit 1
This command will recover the OSM from shutdown or other failed state.
Warning: This command may lose the data on the hard disk if the OSM is n
ot being shut down!
Continue? [Y/N]:y
Reboot OSM by command!