Access Controller xl Module Management and Configuration Guide 2005-03

Using 5300xl Features with the Access Controller xl Module
Table 1. 5300xl Switch Features Not Supported on an ACM (Continued)
Downlink Client Ports Downlink Port Client VLANs Uplink Port
Feature Explanation
Configuring IP
Addresses
x Not allowed.
DHCP/DHCP Relay
x Not allowed.
IP Helper Address
x Not allowed.
Flow Control
Not supported across an ACM.
GVRP
x x x x 1. GVRP cannot be enabled on an uplink,
downlink, or downlink client port.
2. A port in a GVRP VLAN cannot be added
to a client VLAN.
3. If GVRP is enabled on a port when it is
added to a client VLAN, it is disabled.
IGMP
x x x IGMP cannot be enabled on client
VLANs.As a result, it cannot be enabled on
downlink client ports.
Interface Monitoring
x x x Cannot be used as a monitoring port.
(Port Mirroring)
Interface Provisioning:
Speed
Duplex
Flow-Control
Auto-MDIX mode
x x Fixed at 1000Mbps.
x x Fixed at Full-Duplex.
x x Not allowed.
x x Not allowed.
IP Routing/
Multicast Routing
x
x
No routing is done.
Not allowed.
IP Stacking
Not supported across an ACM.
IRDP
x Not allowed.
Link Test
x x Test packets not supported across an ACM.
LLDP
x x Set to off.
‘x’ indicates that the feature is not supported.
7