Access Controller xl Module Management and Configuration Guide 2005-03

------------ ----------
Configuring the Access Controller xl Module
HP ProCurve Switch 5308xl(config)# access-controller b client-ports a2,a6
HP ProCurve Switch 5308xl(config)# access-controller b
HP ProCurve Switch 5308xl(access-controller-B)# show vlans
Downlink:
VLAN ID VLAN Name Ports
2000 VLAN2000 A2,BDP
2001 VLAN2001 A6,BDP
Uplink:
VLAN ID VLAN Name Ports
1 DEFAULT_VLAN A1,A3-A5,A7-A24,BUP
HP ProCurve Switch 5308xl(config)# show vlans 2000
Status and Counters - VLAN Information - Ports - VLAN 2000
802.1 Q VLAN ID : 2000
Name : VLAN2000
Statu s : Port-based
Voice : No
Port Information Mode Unknown VLAN Status
----- ----------- --------
A2 Untagged Disable Down
BDP Tagged Disable Up
Figure 4. Configuring A Downlink Client Port
Notes on Depending on how many VLANs are already configured in the 5300xl switch,
Creating
the following messages may occur:
Downlink Client
Ports
 Maximum Number of VLANs (X) has already been reached
Increase the maximum number of VLANs allowed on the switch.
 Command will take effect after saving configuration
and reboot.
The switch requires a reboot to incorporate the new client VLANs into
the system. If downlink client ports are added over a period of time,
a reboot may be required after each addition to make the client VLAN
available.
17