Advanced Services v2 zl Module Quickstart Guide

HP Advanced Services v2 zl Module Quickstart 4 Front panel LEDs
8. To switch to the module serial console from the switch CLI prompt, enter:
services
<slot-id> serial
The module boots from the USB flash drive. You can now install VMware
vSphere 5.5 ISO image on the Advanced Services v2 zl Module. Follow
the instructions from the VMware’s Installation and Setup Guide to install
the image.
Boot from Preboot Execution Environment (PXE)
You can boot the Advanced Services v2 zl Module using the PXE boot. For
more information about PXE boot, see the VMware vSphere Installation
Guide. By default PXE boot is not enabled.
1. To enable PXE boot, at the switch CLI prompt, go to configure mode and
enter:
services <slot-id> device pxe
2. To disable PXE boot, at the switch CLI prompt, go to configure mode and
enter:
no services <slot-id> device pxe
Note:
When you reboot the module, the module boots from PXE boot
through the
two GbE ethernet ports.
Shutdown button
The Shutdown button is accessible through a hole on the front panel. To shut
down the module gracefully, insert a wooden toothpick into the Shutdown
button hole, and press and immediately (in less than four seconds) release the
button.
To shut down the module when the module is not responding, press and hold
(for more than four seconds) the Shutdown button before releasing.
The Shutdown button is enabled by default but can be disabled through the
switch software.
To disable the Shutdown button, at the switch CLI prompt, go to configure
mode and enter:
no services <slot-id> device shutdown
To enable the Shutdown button enter:
services <slot-id> device shutdown
Front panel LEDs
LED State Meaning
Advanced
Services v2 zl
Status
(green/orange)
Solid green The module is booting or ready.
Flashing green The module is booting or shutting down.
Flashing orange Module error has occurred.
Off The module is powered off.
Solid orange The module self-test is in progress.
Locator (blue) Solid The
services <slot-id>
locator on command was issued to
assist in finding the module.
Flashing The
services <slot-id>
locator blink command was
issued to assist in finding the module.
Off Default state. Otherwise, the
services
<slot-id> locator off
command
was issued or a previous flash request
has timed out.
USB (green) Solid The USB port is enabled and the module
OS recognizes the port.
Off The USB port is disabled and the and the
module OS does not recognize the port.
HDD/SSD
Activity (green)
Flashing The HDD/SSD is active.
Off The HDD/SSD is not active.
Network Activity
(green)
Flashing There is network activity on one or more
internal ports.
Off There is no network activity on any of the
internal ports.
5998-4959_QS_Advanced_Services_v2_zl_Controller.fm Page 4 Wednesday, December 4, 2013 4:26 PM