Avaya Aura Session Border Controller powered by Acme Packet Installation and Getting Started Guide 2010-09

2-5
Hardware Installation
Update the Switch Software
Note If you need to cancel this command, press either [Ctrl-C] or [Ctrl-Z]. Both cancel
the command, but
[Ctrl-Z], unlike [Ctrl-C], does not provide any message indi-
cating that the command was cancelled.
5. After the file has finished copying, you should see the prompt again as
shown in Figure 2-3.
Figure 2-3. HP zl Switch CLI—Software Copied
6. Set the startup-config file for the secondary software:
hostswitch# startup-default secondary config <filename>
For example:
hostswitch# startup-default secondary config config1
If you do not know the name of the config file that you are using, you can
use the help function to see the names of files on your system:
hostswitch# startup-default secondary config ?
7. Reboot the HP zl switch to the secondary software:
hostswitch# boot system flash secondary
8. When prompted to reboot the switch, press
[y].
9. When prompted to save the configuration, press
[y] again.
10. After the switch reloads, reestablish your management session. Then
enter this command to verify that the new software is running:
hostswitch# show version