Avaya Aura Session Border Controller powered by Acme Packet Installation and Getting Started Guide 2010-09

2-6
Hardware Installation
Set the HP zl Switch Time
You should see the following output.
hostswitch: show version
Management Module 1: Active
Image stamp: /sw/code/build/btm(t4a)
Apr 22 2010 20:05:26
K.14.60
69
Boot Image: Secondary
hostswitch#
Set the HP zl Switch Time
To follow best practices, you should ensure that the HP zl switch is using the
correct time. This helps ensure that switch operations can be performed
without error, particularly when the switch is interacting with other applica-
tions and network infrastructure devices. Setting the correct time also ensures
that event logs use the correct time, allowing you to monitor or troubleshoot
problems more easily.
To set the time on the HP zl switch, you can:
■ Synchronize the HP zl switch and the domain controller time using SNTP
(recommended for a permanent installation)
■ Set the HP zl switch time manually
Synchronize the HP zl Switch Using SNTP
To synchronize the HP zl switch time using SNTP, follow these steps:
1. Open a CLI management session with the HP zl switch and access the
global configuration context:
hostswitch# config
2. Enable SNTP:
hostswitch# timesync sntp
3. Set the SNTP mode:
hostswitch# sntp unicast