Avaya Aura Session Border Controller powered by Acme Packet Installation and Getting Started Guide 2010-09

2-7
Hardware Installation
Set the HP zl Switch Time
4. Configure the SNTP server IP address (either the domain controller or an
SNTP server with the correct time):
5. Set the timezone:
6. If you plan to activate Daylight Saving Time on the ONE-integrated
application, you must activate it on the HP zl switch:
7. Check the switch time and verify that it is correct:
hostswitch(config)# clock
8. Save the changes:
hostswitch(config)# write memory
Set the HP zl Switch Time Manually
Follow these steps:
1. Open a CLI management session with the HP zl switch and access the
global configuration context:
hostswitch# config
Syntax: sntp server priority 1 <ip-address>
Replace <ip-address> with the reachable IP address of the
domain controller or SNTP server.
Syntax: time timezone <-780 - 840>
The switch calculates the time zone offset in minutes. For
example, to specify GMT +1, type 60.
Syntax: time daylight-time-rule < none | alaska | continental-us-and-canada |
middle-europe-and-portugal | southern-hemisphere | western-
europe |user-defined>
Select the region that applies to you.