Avaya Aura Session Border Controller powered by Acme Packet Installation and Getting Started Guide 2010-09

C-1

Hardware Components

Front Panel Buttons, LEDs, and Connectors

Hardware Components

Front Panel Buttons, LEDs, and Connectors

This section describes the different buttons, LEDs, and connectors on the front panel

of a module:

■ Module Shutdown button—This button is used to shut down the module. A

message is written to the switch log to indicate the module has shut down. If the

button is pressed briefly (for approximately one second), a graceful shutdown

takes place; in this case file integrity and data is protected. If the button is pressed

and held (for four seconds or longer), a hard shutdown takes place.

Note the module can also be shut down by using a CLI command.

Note also that the shutdown button can be enabled and disabled using a CLI

command. See “Device Disable” on page D-5.

■ 10/100/1000T Management Port—This port provides an out-of-band connec-

tion to the System Platform for management, typically in troubleshooting

situations. Traffic is not routed through this port beyond the module.

Connect through this port using SSH from a laptop or terminal with IP address:

192.11.13.5. Only console devices should be connected to the Management port.

To limit access, do NOT connect the Management port to a switch port.

■ USB Port—This port is used to attach a USB device, such as a flash drive.