Field Replaceable Units (FRU) Guide, HP Advanced and Extended Services zl Modules 2011-03

6
Hardware Replacement Procedures
Hardware Replacement Procedures
This section describes the procedures to replace each of the FRUs. The
procedures are essentially the same for each of the HP AllianceONE Services
zl Module products.
Replacing the HDD
The following is the procedure for replacing the HDD in the module. The
numbers in Figures 4a and 4b correspond to the step numbers below.
The module may be removed while the switch is powered on, but it is
recommended that you first shut down the module. From the switch CLI
prompt, enter the shutdown command:
hostswitch# service <slot-ID> shutdown
where <slot-ID> is the letter identifier for the slot in which the module is
installed. The module is completely shut down when all its LEDs are OFF. In
addition, you can identify that the module is shut down by entering the show
services command at the switch CLI prompt. When the module is shut down,
its slot ID will not be shown in the Slot column in the output for that command.
1. Using either a flat-bladed or Torx T-10 screwdriver loosen the retaining
screws securing the module.
2. Using the extractor handles, pull the module out from the slot(s). Avoid
touching any of the components or circuitry on any of the boards.
1.
Retaining Screws
2.
Extractor Handles
Figure 4a. Steps for Replacing the Module’s Disk Drive(s)