Field Replaceable Units (FRU) Guide, HP Advanced and Extended Services zl Modules 2011-03

Restoring Product Operation

HP Advanced Services zl Module

Follow these procedures to restore your HP Advanced Services zl Module and

the ONE-App for which you were using the module to full operation.

After HDD Replacement

For the HP Advance Services zl Module, the ONE-App product installation

process stored the application and the operating system for that application

onto the zl Module’s HDD. Your replacement HDD will be blank. After

replacing the HDD, you will need to complete these steps:

1. Re-download the ONE-App, if you no longer have the download image

copied onto the module’s CF.

2. Redo the installation and activation of the ONE-App.

See Chapter 2, “Getting Started” of the HP Advanced Services zl Module

Installation and Getting Started Guide for information on these procedures.

After CF Replacement

Your replacement CF should have the correct Service OS for the HP Advanced

Services zl Module installed on it. As part of the troubleshooting process to

identify that the CF was faulty, you probably booted the module into the

Service OS. In that case, after installing the new CF, when you re-install the

module into the switch, the module should automatically boot into the Service

OS.

You can confirm that by entering this command from the switch prompt:

hostswitch# services <slot-ID> 1

where: <slot-ID> is the letter identifier of the switch slot in which the

module is installed. The index number 1 (one) is the context identifier for

the module, not the application running on the module.

If the module has booted into the Service OS, the prompt will include the

characters :SvcOS)# at the end.

Confirm that the CF installation has occurred without any issues by entering

the following command from the Service OS prompt:

:SvcOS)# show version details