Field Replaceable Units (FRU) Guide, HP Advanced and Extended Services zl Modules 2011-03

Restoring Product Operation

The output from this command should show the correct product information

for the HP Advanced Services zl Module product and the ONE-App that you

installed previously.

From the Service OS prompt, reboot the module into the product OS with the

command:

:SvcOS)# boot ONE-app

At this point, normal operation should be restored.

After zl Module Replacement

After installing your original HDD and CF into the replacement zl Module and

installing the module into the switch (as described earlier in this document),

depending on the ONE-App that you are using, you may have to re-install the

ONE-App activation licensing. See “One-App Activation” in Appendix D, “Soft-

ware Components” of the HP Advanced Services zl Module Installation and

Getting Started Guide.

Once that licensing is complete, if necessary, normal operation should be

restored.

Riverbed AllianceONE zl Module

Follow these procedures to restore your Riverbed AllianceONE zl Module

product to full operation if you have had to replace the HDD, the CF, or the zl

Module.

After HDD Replacement

Your replacement HDD should be imaged with a stable code base that includes

the Riverbed Steelhead application and the OS that the application needs to

operate on the module.

After installing the new HDD, when you reinstall the module in the switch, as

described in the replacement procedures earlier in this document, the module

should automatically boot to the product OS. You can confirm that by entering

this command from the switch prompt:

hostswitch# services <slot-ID> 1

where: <slot-ID> is the letter identifier of the switch slot in which the

module is installed. The index number 1 (one) is the context identifier for

the module, not the application running on the module.

If the module has booted into the product OS, the prompt will include the

characters :App)# at the end.