Field Replaceable Units (FRU) Guide, HP Advanced and Extended Services zl Modules 2011-03

Restoring Product Operation

After zl Module Replacement

After installing your original HDD and CF into the replacement zl Module and

installing the module into the switch, you should not experience any need for

reconfiguration, or re-licensing of the Riverbed application product. Normal

operation should be automatically restored.

SBM AllianceONE zl Module

Follow these procedures to restore your SBM AllianceONE zl Module product

to full operation if you have had to replace the HDD, the CF, zl Module, or one

or more of the PCIe cards.

After HDD Replacement

Your replacement HDD should be imaged with a stable code base.

After installing the new HDD, when you reinstall the module in the switch, as

described in the replacement procedures earlier in this document, the module

should automatically boot to the product OS. You can confirm that by entering

this command from the switch prompt:

hostswitch# services <slot-ID> 1

where: <slot-ID> is the letter identifier of the switch slot in which the

module is installed. The index number 1 (one) is the context identifier for

the module, not the application running on the module.

If the module has booted into the product OS, the prompt will include the

characters :App)# at the end.

If the module has booted into the Service OS, the prompt will include the

characters :SvcOS)# at the end.

You will have to perform a configuration of the module again, as if it is a first

time installation. For these procedures, please refer to chapter 2, “Getting

Started” in the HP SBM Installation and Getting Started Guide.

You will need to reset the SBM application Module’s computer object in Active

Directory per Microsoft instructions. Otherwise MSMQ problems cause Lync

Logging and Archiving to not perform correctly.

After CF Replacement

As part of the troubleshooting process to identify that the CF was faulty, you

probably booted the module into the Service OS. In that case, after installing

the new CF, when you install the module into the switch, the module will

automatically boot into the Service OS.