Field Replaceable Units (FRU) Guide, HP Advanced and Extended Services zl Modules 2011-03

Introduction

This document described the procedures to replace the components that are

designed to be replaceable for the following products:

■ HP Advanced Services zl Module

■ HP AllianceONE Extended Services zl Module with Riverbed® Steel-

head® RiOS® Application (referred to as the Riverbed AllianceONE zl

Module product in this document)

■ HP Survivable Branch Communications zl Module with Microsoft OCS

Branch Application (referred to as the SBM AllianceONE zl Module

product in this document)

■ HP AllianceONE Extended Services zl Module for Avaya Aura Session

Border Controller powered by Acme Packets (referred to as the SBC

AllianceONE zl Module product in this document)

Field Replaceable Units (FRUs)

For each of the listed products, the FRUs include the hard disk (HDD), the

compact flash (CF), and the zl Module itself. The part numbers for these items

are listed under “FRU Part Numbers” on page 20 of this document.

For the SBM AllianceONE zl Module product, there are also PCIe cards

installed which are field replaceable. For information about replacing PCIe

cards, see “Replacing the SBM Product PCIe Cards” on page 11, and see the

insert that ships with those cards.

HDD

Depending on the product you have, the HDD is located either on the top board

(referred to as the Upper Deck), attached to four short stand-offs, or on the

bottom side of the bottom board (referred to as the Lower Deck), attached to

a frame. Note that for the HP product, there is a single board. The HDD is on

the bottom side of that board attached to a frame.

For all the products, the CF is installed on the bottom of the bottom board,

for the two-board models, or the bottom of the single board.