Field Replaceable Units (FRU) Guide, HP Advanced and Extended Services zl Modules 2011-11

12
Restoring Product Operation
Restoring Product Operation
HP Advanced Services zl Module
Follow these procedures to restore your HP Advanced Services zl Module and
its ONE-App software to full operation.
HDD Replacement
For the HP Advance Services zl Module, the ONE-App installation process
stored the application and the operating system for that application on the zl
Module’s HDD. Your replacement HDD will be blank. After replacing the HDD,
you will need to complete these steps:
1. Re-download the ONE-App application, if you no longer have the down-
load image copied onto the module’s CF.
2. Redo the installation and activation of the ONE-App.
See Chapter 2, “Getting Started” of the HP Advanced Services zl Module
Installation and Getting Started Guide for information on these procedures.
CF Replacement
Your replacement CF should have the correct Service OS for the HP Advanced
Services zl Module installed on it. As part of the troubleshooting process to
identify that the CF was faulty, you probably booted the module into the
Service OS. In that case, after installing the new CF, when you re-install the
module into the switch, the module should automatically boot into the Service
OS.
You can confirm this by entering this command from the switch prompt:
HP Switch# services <slot-ID> 1
where: <slot-ID> is the letter identifier of the switch slot in which the
module is installed. The index number 1 (one) is the context identifier for
the module, not the application running on the module.
If the module has booted into the Service OS, the prompt will include the
characters :SvcOS)# at the end.
Confirm that the CF installation has occurred without any issues by entering
the following command from the Service OS prompt:
:SvcOS)# show version details