Field Replaceable Units (FRU) Guide, HP Advanced and Extended Services zl Modules 2011-11

20
Restoring Product Operation
HP Switch# services <slot-ID> 1
where: <slot-ID> is the letter identifier of the switch slot in which the
module is installed. The index number 1 (one) is the context identifier for
the module, not the application running on the module.
If the module has booted into the Service OS, the prompt will include the
characters :SvcOS)# at the end.
Confirm that the CF installation has occurred without any issues by entering
the following command from the Service OS prompt:
:SvcOS)# show version details
The output from this command should show the correct product information
for the HP Advanced Services zl Module product and the ONE-App that you
installed previously.
From the Service OS prompt, reboot the module into the product OS with the
command:
:SvcOS)# boot ONE-app
At this point, normal operation should be restored.
zl Module Replacement
After installing your original HDD and CF into the replacement zl Module and
installing the module into the switch (as described earlier in this document),
it is unlikely, but you may have to re-install the VMWare activation licensing.
If so, see “Installing HP and VMware Licenses” in Appendix D, “Software
Components” of the HP Advanced Services zl Module with VMware®
vSphere™ Platform Installation and Getting Started Guide.
Once that licensing is complete, if necessary, normal operation should be
restored.