Getting Started Guide 2007-07

18
Getting Started
Step 6 - Verify Radio Port adoption.
To verify that the radio ports have been adopted by the Module, select Device
Information > Radio Adoption Statistics.
If some of the radio ports are not found on this screen, check the status of the
LEDs on the missing radio ports.
• If both the LEDs blink about once every 5 seconds, the Radio Port is
adopted and ready for use.
• If the amber light is continuously blinking, with the green light out.
the radio port is in the unadopted mode. In this case, please refer to
the appropriate Radio Port Installation and Getting Started Guide
for troubleshooting information. The guides are available at
www.procurve.com.
Step 7 - Configure the Module.
You must configure the Module to assign user-specified WLANs to Radio Ports.
This section provides configuration examples using Normal Mode, which is
suitable in most cases. You simply configure and enable WLANs, and adopted
RPs begin to support those WLANs automatically. In Normal Mode configura-
tion, the Module and RPs are limited to 16 WLANs.
Advanced Mode is performed manually, to control WLAN assignment to Radio
Ports or to extend the number of WLANs. For more information, see the
Management and Configuration Guide for the Wireless Edge Services zl
Module.