Getting Started Guide for Wireless EDGE Services xl Modules 2007-07

9
Getting Started
A wireless services-enabled Switch 5300xl has the following recommended
minimum requirements:
• ProCurve Switch 5300xl must be connected to a network with DHCP
services enabled, or have a local DHCP service to provide IP
addresses.
• ProCurve Switch 5300xl must have at least one module for connecting
to the wired network.
• ProCurve Switch 5300xl must have at least one ProCurve Switch xl
10/100-TX PoE Module (J8161A), if the radio ports are connected
directly to the switch.
For the example equipment listed above, a sample setup is shown below
Switch 5305xl (J4819A)
B - Wireless Edge Services
xl Module (J9001A)
Network
Radio Port 230 or 210
(J9006A or J9004A)
D - PoE xl Module
(J8161A)
A - 10/100 Tx sl Module
(J4820A)
B - Switch xl 16-port
10/100/1000 Module
(J4907A)
610 EPS (J8169A)
Note: A,B,C, D refer to the module slot of the Switch 5304xl