Getting Started Guide for Wireless EDGE Services xl Modules 2007-07

Getting Started

2. If no DHCP service is available or if the administrator wishes to manually

set the Module IP Address, it can be specified by using the CLI, as shown

below in the following CLI commands. In this example the IP address is

set to 10.245.22.14

Step 4 - Launch Module’s Web browser interface.

1. Open a browser on the network connected PC, and type in the URL for

the Module. In this example, it is http://10.168.2.5.

2. A Java applet is required to open the Module web browser. If the PC does

not have this software, JVM will be automatically downloaded to the PC

via an internet connection.

3. The first page that may appear is the "Security-Warning", including the

question, "The application’s signature is invalid. Do you want to run the

applications?" Select the Run button to proceed.

ProCurve# configure

ProCurve(config)# wireless-services c

ProCurve(wireless-services-C)#show ip interface

Interface IP-Address Status Protocol

vlan1 10.168.2.5(DHCP) up up

ProCurve(wireless-services-C)#

ProCurve(wireless-services-B)(config)#interface vlan1

ProCurve(wireless-services-B)(config-if)#ip address 10.245.22.14/21

ProCurve(wireless-services-B)(config-if)#show ip interface

Interface IP-Address Status

Protocol

vlan1 10.245.22.14 up up

ProCurve(wireless-services-B)(config-if)#