Getting Started Guide for Wireless EDGE Services xl Modules 2007-07

29
Getting Started
Configuration 3 - Adding redundancy.
In this case the following modules will be set up in a Redundancy Group
■ ProCurve Module (J9001A).
■ ProCurve Redundant Wireless Services xl Module (J9003A).
Note: For the optimal redundancy and protection, the preferred setup is for
the J9001A and J9003A to be installed in different chassis. However, these
modules may be installed in the same chassis.
1. Verify that the IP addresses for the two modules are in the same VLAN.
2. Select Network Setup> Redundancy Group > Configuration. On this
screen,
– Enter the Interface IP for the J9001A module, and the Redundancy
Group ID number.
– Select the Mode, ’Active’. This is the default mode.
– Nominal setting are shown in this screen for the other settings:
Discovery Period, Heartbeat Period, Hold Period. Refer to the Help
menu, or the ProCurve Module Management and Configuration
Guide for additional information on these selections.
– Select Apply to save the setting for this session.