Getting Started Guide for Wireless EDGE Services xl Modules 2007-07

30
Getting Started
– This screen notes that the Redundancy state is currently
’Disabled’.
– This screen is shown below:
3. The next step is to add the IP address of the redundant member, 9003A.
Select the screen Network Setup > Redundancy Group> Member. Select
Add and a pop-up screen appears. Enter the IP address of the new Group
member (9003A). Select OK to return to the main screen.
4. Next, repeat these steps with the J9003A module, using its IP address for
the Interface IP, and the IP address of the J9001A module as the Member.
Typically, the J9003A module is operated in the Standby mode (This is the
default mode).
5. Select Network Setup > Redundancy Group > Configuration. Check the
box for Enable Redundancy, and select the Apply button to save the setting
for this session. Note that the Redundancy status is ’Online’ and the Group
Connectivity Status is ’All Members connected’. The screen may need to
be refreshed to get the current status, as the Redundancy Group formation
takes a few moments.
6. Select Save to save the settings in a non-volatile memory in the Module.
Repeat this step for both modules.
The two modules, J9001A and J9003A are now operating as a Redundancy
Group.