H3C SECBLADELB-CMW520-R3204P17 - Release Notes

l file file-url: Name of the boot file, consisting of 1 to 64 characters.

l main: Main application file.

l backup: Backup application file.

l A boot file is an application file used to boot the SecBlade card. When there are multiple

application files on the CF card, you can use the boot-loader command to specify an application

file for the next boot. The main application file is used to boot the SecBlade card. The backup

application file is used to boot the SecBlade card when the main application file is unavailable.

l The SSL VPN cards do not support the boot-loader command. You can specify an application

file for the next boot by configuring the attribute of the application file to M on the BootWare menu.

Specifying a configuration file

Use the startup saved-configuration cfgfile command in user view to specify a configuration file for

the next boot and then restart the device. In the command, cfgfile is the name of the configuration file.

Application Upgrade on the Web Interface

SecBlade cards support Web-based network management. The network administrator can

conveniently, visually manage, maintain, and upgrade the cards on the Web interface. Default Web

Table 9 Default Web login information for SecBlade cards

Username h3c

Password h3c

Interface GigabitEthernet0/1

Interface IP address 192.168.0.1/24

Preparations for Software Upgrade

Before software upgrade on the Web interface, connect a terminal (usually a PC) to an interface (for

example, GigabitEthernet 0/1) on the SecBlade card and configure a route between them as follows:

Step1 Install the SecBlade card in the S7500E/S9500/S9500E in the way you install an LPU and ensure that

the switch works normally. For details about the installation, refer to H3C S7500E Series Routing

Switches Installation Manual or H3C S9500 Series Routing Switches Installation Manual or H3C

S9500E Series Routing Switches Installation Manual.

Step2 Connect a PC to interface GigabitEthernet 0/1 of the SecBlade card with a crossover Ethernet cable.

Step3 Configure an IP address for the PC and ensure that the PC and the interface are on the same

network segment.