7500 20Gbps VPN Firewall Card Manual-6P103

Manual Version: 6P103-20130916 BOM:

3123A0MP

Part number: 5998-3445

4.2

Removing the LSU1FWCEA0 (JG372A) module

1. Use a Phillips screwdriver to loosen the captive screws at both sides of the module until all pressure

is released.

2. Pull the ejector levers at both sides of the module outward, and pull the module along the guide

rails until it completely comes out of the backplane.

3. Place the module on an anti-static workbench with the surface-mounted components up, or put it in

an anti-static bag.

4. If no new module is to be installed, install a filler panel to prevent dust and ensure good ventilation

in the switch.

5 Logging in to the LSU1FWCEA0 (JG372A) module

Table 6 Log in to the module through OAP

Task Command

Remarks

through OAP.

• In standalone mode:

oap connect slot slot-number

• In IRF mode:

oap connect chassis chassis-number slot

slot-number

Available in user view of the

switch.

To return to the CLI interface of the

switch, press Ctrl+K.

NOTE:

In addition to this login method, you can also log in to the firewall module through Web, Telnet, SSH, or

console port. For more information about these login methods, see

HP VPN Firewall Appliances

Configuration Guides

6 Software upgrade

You can upgrade the LSU1FWCEA0 (JG372A) module software through its console port or Ethernet

ports.

The LSU1FWCEA0 (JG372A) module uses a different BootWare and system software image than the

switch. You can upgrade the system software image of the module by using the following methods:

6.1

Upgrading software in the Web interface

You can use the following default settings to log in to the Web interface through HTTP:

• Username—admin

• Password—admin

• IP address of the Ethernet port GigabitEthernet 0/1— 19 2 .16 8 . 0 .1 / 2 4 .

To upgrade software in the Web interface, select Device Management > Software Upgrade from the

navigation tree, and perform related configurations on the page.

The software upgrade process takes some time. During the upgrade process, do not perform any

operation in the Web interface. Otherwise, software upgrade may be interrupted.