HP Advanced Services v2 zl Module Installation Guide

1 Preparing for installation
The HP Advanced Services v2 zl Module is a module that you can plug into switch chassis such
as the 5406zl, 5412zl, 8206zl, and 8212zl. Read the switch documentation to prepare the switch
before you plug in the HP Advanced Services v2 zl Module.
NOTE: The HP Advanced Services v2 zl Module requires at least Version K.15.14.xxxx or later
on the switch.
Identifying module components
Front panel and LEDs
Figure 1 Module front panel
3. LAN port2. Module Shutdown button1. Module Status LED
6. VGA port5. USB port4. USB Enable LED
8. Locator LED7. Network and HDD/SSD Activity
LEDs
Front panel LEDs indicate the following:
MeaningStateLED
The module is booting or ready.Solid greenModule Status
(green/orange)
The module is booting or shutting down.Flashing green
An error has occurred.Flashing orange
The module is powered off.Off
The module self-test is in progress.Solid orange
The port is enabled and is receiving a strong signal from
the connected device.
Solid greenLAN Port Link LED
(green/orange)
The port has no active network cable connected or a solid
link has not been achieved.
Off
The corresponding port has failed its self-test or a fault
condition has occurred on the port.
Flashing orange
There is network activity on the external LAN port.Flashing greenLAN Port Activity LED (green)
There is no network activity on the external LAN port.Off
4 Preparing for installation