HP Advanced Services v2 zl Module Installation Guide

MeaningStateLED
The services <slot-id> locator on command was
issued to assist in finding the module.
SolidLocator (blue)
The services <slot-id> locator blink command
was issued to assist in finding the module.
NOTE: Flashing duration defaults to 30 minutes, but can
be set anywhere from 1 minute to 1440 minutes.
Flashing
Default state. Otherwise, the services <slot-id>
locator off command was issued or a previous blink
request has timed out.
Off
The USB port is enabled and you can boot the module from
bootable devices connected to the USB port.
Solid (Pre-BIOS screen)USB Enable LED (green)
The USB port is enabled and the module OS recognizes the
port.
Solid (Post-BIOS screen)
You cannot boot the module by connecting bootable devices
to the USB port.
Off (Pre-BIOS screen)
The USB port is disabled and the module OS does not
recognize the port.
Off (Post-BIOS screen)
The HDD or SSD is active.FlashingHDD/SSD Activity (green)
The HDD or SSD is not active.Off
There is network activity on one or more of the internal ports.FlashingNetwork Activity (green)
There is no network activity on any internal port.Off
Switch LEDs
The following figures show the Test, Fault, and Module Status LEDs on the switches in which the
module can be installed.
Figure 2 Test, Fault, and Module Status LEDs on a Series 54xxzl switch
1. Fault LED
2. Test LED
3. Module Status LEDs
Switch LEDs 5