HP Advanced Services v2 zl Module Installation Guide

is installed while the switch already has power. The switch and module LEDs indicate if the module
has passed the self-test, as described in the following table.
NOTE: At power-on and during module self-tests, all LEDs turn on for at least 7 seconds and go
through their range of colors. Once the self-tests have completed, all LEDs return to behaving
normally.
Display for a properly installed moduleLocation of LEDLED
Off.
Note: If the module was installed with the switch powered off,
and then the switch was powered on, the Test LED will stay on for
the duration of the switch self-test.
SwitchTest
Figure 2 (page 5) and Figure 3 (page 6) show the location of
the Test, Fault, and Status LEDs on a 54xxzl or 82xxzl series
switch, respectively.
Off.SwitchFault
On.SwitchModule Status
Solid green.
“Module front panel” (page 4) shows the location of all module
LEDs.
ModuleModule Status
Flashing green when HDD or SSD is accessed.ModuleHDD or SSD Activity
Error conditions
Error conditions indicated by the module LEDs are described in “Front panel and LEDs” (page 4).
NOTE: Allow sufficient time for the module(s) to start up. If the chassis has already booted and
you are only booting one module, it can take up to one minute. Booting multiple modules at one
time may take longer (several minutes).
Verifying the module is installed correctly 9