HP Advanced Services zl Module with Citrix XenServer™ Platform Installation and Getting Started Guide

1-6
Hardware Installation
Installing the Module
Installation Procedure
1. Confirm that the switch time is set and corret as described in the Instal-
lation and Getting Started Guide for the switch at
www.hp.com/networking/support.
2. If installing in an unused slot, use a Torx T-10 or flat-bladed screwdriver
to unscrew the screws in the cover plates over the slot where you will
install the module. Store the cover plates for possible future use.
3. Hold the module by its bulkhead, taking care not to touch the metal
connectors or components on the board.
4. Open the extractor handles.
5. Insert the module, aligning with the guides in the slots, and slide it into
the slot until it is fully inserted.
6. Once the module is fully inserted, use the extractor handles to set it
completely.
7. Tighten the screws.
Figure 1-3. Module Being Installed
Insert module into the guides
and slide in until fully
inserted.
Open extractor handles.