HP Advanced Services zl Module with Citrix XenServer™ Platform Installation and Getting Started Guide

D-3
Software Components
Updating Switch Software
6. When prompted to reboot the switch, press [y].
7. When prompted to save the configuration, press
[y] again.
8. After the switch reloads, reestablish your management session. Then
enter this command to verify that the new software is running:
HP Switch# show version
You should see the following output.
Figure D-2. HP zl Switch CLI—show version Output
Note If a CLI command must be aborted, use either Ctrl-C or Ctrl-Z. The difference
between using the two is that Ctrl-Z, unlike Ctrl-C, does not provide any
message indicating that the command was aborted.
There are some conditions when Ctrl-C may not work; in these cases, use
Ctrl-Z.
HP Switch# show version
Image stamp: /sw/code/build/btm(ec_K_detroit_qaoff)
May 6 2011 14:43:14
K.15.05.0000x
28
Boot Image: Secondary
HP Switch#