HP Advanced Services zl Module with Citrix XenServer™ Platform Installation and Getting Started Guide

E-7
Service OS Command-Line Reference
Service OS Manager Context Commands
Service OS Manager Context Commands
The Service OS manager context allows restricted access to the Service OS of
the module, providing only a limited number of commands. From this mode,
you can download and install software. CLI access to the Service OS is
designed primarily for blade maintenance, not for configuring the module.
The Service OS context is used to complete basic setup and maintenance
tasks. To access this context, enter the following command from the switch’s
manager-level or global configuration context:
For example, if you want to enter the Service OS for the module in slot C, enter:
HP Switch(config)# services c 1
To verify your location in the CLI, check the prompt. In the Service OS manager
context, the prompt is:
■ HP Switch(svcs-mod-<slot ID>:SvcOS)#
This is the prompt that is displayed if you have entered the Service OS CLI
and the Service OS is booted.
The commands in this section are the Service OS CLI manager commands with
the Service OS booted.
(Until the module is booted in the Service OS, you can access a limited set of
commands, including boot, exit, and some show commands.)
Syntax: services <slot ID> 1
Moves you to an OS context on the module.
Replace <slot ID> with the letter for the lower chassis slot in
which the module is installed.
The Service OS context is always assigned index number 1.