HP Advanced Services zl Module with Citrix XenServer™ Platform Installation and Getting Started Guide

1-2
Hardware Installation
Overview
If you want to start immediately, move to “Updating Switch Software” on page
D-1 in Appendix D, “Software Components”. You can obtain more details
about the module in “Module Hardware” on page 1-2 and “Module software”
on page 1-3.
Table 1-1. Installation Process
Module Hardware
The HP Advanced Services Module with Citrix XenServer Platform (J9747A)
is an application running on an HP Advanced Services Module. For a descrip-
tion of the front panel buttons and LEDs, which are identified in the figure
below, see Table C-1 in Appendix C: “Hardware Components.”
Figure 1-1. Module Front Panel
The module is installed in an HP E5400 zl or E8200 zl Series switch.
Important The maximum number of Services zl Modules that can be installed in a switch
chassis depends on the switch model. See Table 1-4 on page 1-8 for details.
Estimated Time Task Reference
25 minutes Install the HP E5400 or E8200 zl
Series switch (if not already
installed)
Installation and Getting Started Guide shipped with your
equipment
8 minutes Update the HP zl switch software Appendix D, “Software Components” - “Updating Switch
Software” on page D-1
2 minutes Set the HP zl switch time Installation and Getting Started Guide shipped with your
equipment
5 minutes Install the module in the HP zl
switch
“Installing the Module” on page 1-5
10 minutes Complete initial setup in the HP zl
switch and module CLI
Chapter 2: “Management”
Module
Shutdown button
Module
Locator LED
HDD and Network
activity LEDs
USB port
Front panel
port
Module Status
LED